(Ref. 128071-001 REV. K)
Voltage and Current Control Mode, Interlock Open and Closed, High Voltage Inhibit, Overcurrent and Overvoltage, Arc, Regulation Error, Overtemperature.
Standard: 208Vac ±10%, 50/60Hz., three phase
Optional: 220Vac ±10%, 50/60Hz., single phase
Models available from 0.5kV to 50kV. Each model is available in positive, negative or reversible polarity output.
Front Panel Controls:
Voltage and current are continuously adjustable by tenturn potentiometers with lockable counting dials, ON/OFF circuit breaker/lamp, high voltage ON switch/indicator and high voltage OFF switch/indicator.
Load: 0.005% of maximum voltage +500mV for full load change. Line: ±0.005% of full voltage +500mV over specified input range
Load: 0.01% of maximum current ±100µA
for full voltage change.
Line: ±0.005% of maximum current for a ±10%
input line change.
0.1% pp +1Vrms, three phase line input
0.3% pp +1Vrms, single phase line input
100ppm/°C voltage or current regulated. Higher
stability is available on special order.
Operating: 0°C to 50°C.
Storage: 40°C to 85°C.
10 to 90% relative humidity, noncondensing
100ppm/hour after 1/2 hour warmup for
both voltage and current regulation.
Digital voltage and current meters, 31/2
digit ±1 least significant digit.
25 pin male D connector
10’ (3.3m) of shielded high voltage
cable removable at the rear panel.
AC Line Input Cable:
A 6 foot (1.83m) cable is permanently attached to the unit. Single phase units use 3 conductor 12AWG cable, three phase units use 4 conductor 16AWG cable.
31/2”H(2U) x 19”W x 19”D
(8.9cm x 48.3cm x 48.3cm).
17 to 26lbs (7.7 to 11.8kg) depending on model.
Compliant to EEC EMC Directive for 3 phase units,
conducted and radiated emission only for single phase units. Compliant to EEC Low Voltage Directive. RoHS Compliant.