CZE1000R

  • 静电纺丝理想之选
  • 0-30kV 本地或远程编程
  • 0-300μA 本地或远程编程
  • 极性可逆,根据指令在<1 秒内完成 (无负载情况下)。
  • 低的存储能量,电流限制输出。
  • 全功能前面板,适合实验室使用。

自动逆变高压电源

斯派曼CZE1000R 是一个全功能的机架式安装的高压电源,实验室使用的理想之选。以满足需要一个“热切换”可逆的输出电压而设计。输出极性可以通过前面板开关快速并安全地反转。

输出电压和电流通过十圈可锁定计数刻度盘,从0 至30kV 和0 至300uA 是完全可调的。通过0 至+10Vdc 编程信号进行远程控制操作;这个信号由用户产生或使用提供的+10 Vdc 参考并使用外部的电位器。

前面板上的电压和电流表提供本地监测。提供电压和电流测试点,0 至10Vdc 对应0 至100% 额定输出。

为了外部高压可接近的区域的防护,提供双位常闭的外部互锁。如果互锁是开着的,高压将关掉并在小于一秒内归零;在互锁闭合之前,高压不能被激活。

卓越的负载和输入调节规格与CZE1000R 出色的稳定性和低纹波保证了一个稳定的高压输出,实现了一致的工艺效果。

典型应用:

  • 静电纺丝
  • 质谱分析
  • 毛细管电泳
  • 静电研究

CE Marking

规格

(Ref. 128075-001 REV. F)

Input Voltage:

115Vac, ±10%, 50/60Hz

Input Current:

Less than 1 amp

Efficiency:

75% typical

Output Voltage:

0 to 30kV

Polarity:

Auto reversible via front panel switch

Output Current:

0 to 300µA

Power:

9 watts, maximum

Line Regulation:

0.01% for a 10% input voltage change

Load Regulation:

0.01% for a full load change

Ripple:

0.1% Vp-p

Stability:

0.02% per 8 hours (after 1/2 hr warmup)

NL Time Constant:

100ms

Stored Energy:

0.2 Joules at 30kV

Temperature Coefficient:

100ppm/°C

Operating Temperature:

0°C to 40°C

Storage Temperature:

-40°C to 85°C

Humidity:

10% to 85% RH, non condensing

Cooling:

Convection cooled

Dimensions:

5.25”H x 19”W x 17”D (13.3cm x 48.3cm x 43.2cm).

Weight:

22lbs. (10kg)

Interface Connector:

14 pin terminal block

AC Input Connector:

IEC320 connector with 6’ (1.83m) cord

HV Output Connector:

Detachable 36. (0.91m) cable provided

Regulatory Approvals:

Compliant to 2014/30/EU, the EMC Directive and 2014/35/EU, the Low Voltage Directive.

OPTIONS

220 220Vac Input VoltageRPO Rear Panel HV Output

CZE100R TERMINAL BLOCK 14 PIN

Pin Signal Parameters
1 +10Vdc Reference Output +10Vdc, 4mA maximum
2 Internal Voltage Control Front Panel Program Voltage (programming potentiometer)
3 Voltage Program Input 0 to 10Vdc = 0 to 100% rated output, Zin =10MΩ
4 Internal Current Control Front Panel Current Control
(programming potentiometer)
5 Current Program Input 0 to 10Vdc = 0 to 100% rated output,
Zin =10MΩ
6 Signal Common Ground
7 Voltage Test Point 0 to 10Vdc = 0 to 100% rated output, Zout =10kΩ, 1%
8 Current Test Point 0 to 10Vdc = 0 to 100% rated output, Zout =10kΩ, 1%
9 External Interlock Out 32Vdc @ 2 amps, max, (connect to pin 10 through safety switch)
10 External Interlock In Return for interlock (connect to pin 9 through safety switch)
11 +10Vdc Reference Output +10Vdc, 4mA maximum
12 Enable Open or ground = HV OFF, >3.4Vdc (up to 15Vdc) = HV ON
13 Spare No Connection
14 Spare No Connection

Note:

The unit is shipped with the following pins jumpered for front panel
operation: 2-3, 4-5, 9-10, 11-12 It is strongly recommended to
remove the 9-10 jumper and use a high voltage safety interlock
switch.

High Voltage Cable:

A mating high voltage connecter is provide with the unit. Have a
spare on hand or replace broken/lost mating high voltage cables
by ordering Spellman part number 105719-034

表和图

DIMENSIONS: in.[mm]

FRONT VIEW

CZE1000R 自动逆变高压电源 (Image 2)

TOP VIEW

CZE1000R 自动逆变高压电源 (Image 3)

BACK VIEW

CZE1000R 自动逆变高压电源 (Image 4)

Note: All specifications are subject to change without notice. Please consult the PDF version of this datasheet for the most up-to-date revision.